WF clutch issues

RichH
Senior Member

Posts: 443

WF clutch issues Sept 28, 2014 16:48:02 GMT -5

Quote

Post by RichH on Sept 28, 2014 16:48:02 GMT -5

Just thought I would start a dedicated clutch thread so we could find it later. Just read this on Bob's and thought it could defiantly could apply to our clutch bearings walking out.

karting.4cycle.com/showthread.php?33297-L206-Clutch-Problem

If you haven't spun in every corner then you haven't practiced hard enough

viacruc
Full Member

Posts: 205

WF clutch issues Oct 16, 2014 22:41:31 GMT -5

Quote

Post by viacruc on Oct 16, 2014 22:41:31 GMT -5

Thanks for the link Rich. I'll have to find some of that sleeve retainer.

Bad news. After the Dixon race last weekend,my clutch was locked solid. I removed it from the crank, removed the circlip and spacer and unfortunately cannot remove the drum from the center shaft.

Does anyone have a press so that i can try to press the shaft out of the bearing? I'm desparate

"If you don't go for the gap, you're not a racer"
-Ayrton Senna

Dan Pell Full Member Posts: 213	WF clutch issues Oct 17, 2014 11:00:53 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Dan Pell on Oct 17, 2014 11:00:53 GMT -5 Paul- send me that clutch, i'll see if it can be fixed, or will have the manufacturer replace parts.

viacruc Full Member Posts: 205	WF clutch issues Oct 17, 2014 17:49:22 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by viacruc on Oct 17, 2014 17:49:22 GMT -5 Thanks Dan. I'll get that shipped out tomorrow morning. What address do I send it to?
	"If you don't go for the gap, you're not a racer" -Ayrton Senna

Message Board

Post by RichH on Sept 28, 2014 16:48:02 GMT -5

Post by viacruc on Oct 16, 2014 22:41:31 GMT -5

Post by Dan Pell on Oct 17, 2014 11:00:53 GMT -5

Post by viacruc on Oct 17, 2014 17:49:22 GMT -5

Quick Reply

Shoutbox