|
|
Post by norcalacr on Dec 22, 2010 22:29:42 GMT -5
Brad W has graciously agreed to again host our scheduling meeting. Send Brad or me a PM for the address.
I have started collecting the schedules in a spreadsheet. Send me a note if you'd like a copy.
For the first timers we gather in Brad's garage (dress appropriately), eat pizza (bring cash), and drink beer (allegedly). Oh, and decide where to race.
See you there.
|
|
|
|
Post by norcalacr on Jan 11, 2011 10:35:58 GMT -5
Reminder - scheduling meeting this Saturday. We will be gathering at noon.
In addition to setting the schedule for 2011 this will be an opportunity to get your kart ready. Brad42 will bring his scales and alignment tools. And there will be plenty of folks available to lend a hand with any wrenching needed.
|
|
|
|
Post by brad42 on Jan 11, 2011 16:16:08 GMT -5
Brad W's address is posted in the member's section.
|
|
|
|
Post by Brad Wunder on Jan 14, 2011 16:04:01 GMT -5
During our conference all earlier this week someone (maybe more than one?) said that they have one of those portable propane heaters and might be willing to bring it along? If you've got the heater, I've got the propane. We've never bothered with heat in the NFRA clubhouse (OK, my garage ;D) but due to some whinning from parties that will remain unnamed (OK, the driver of the #87 kart) it might be nice to have a little heat? Obviously we'll have to keep the door open but since it looks like we are going to have quite a few karts getting scaled, aligned, and various other things the door will most likely be open for most of the day anyway.
|
|
|
|
Post by Brad Wunder on Jan 16, 2011 20:25:53 GMT -5
For those of you who were working on your karts could you please check your toolbox for me? I'm missing 1/2X3/8 socket (which I use ALL the time), 1/4 driver ratchet, and 4mm t-handle allen.
|
|
|
|
Post by Mac on Jan 16, 2011 20:46:35 GMT -5
Let me look Brad. I tried to make sure I put everything back but perhaps I walked off with something. I know you took you 4mm wrench back at one point to adjust something and I never used it again.
|
|
|
|
Post by Brad Wunder on Jan 16, 2011 20:57:41 GMT -5
Yeah I got the 4mm back but then it got used to tighten the Exact Toe that was being used at the time and I didn't see it after that. Arrrg. I don't thin I've ever needed the 1/4 ratchet but it would be nice to have it. The 1/2 socket is a MUST have item since I use it every time I do anything with my clutch.
|
|
