|
|
Post by RichH on Feb 13, 2011 1:11:19 GMT -5
Got some laps in on the new kart. A couple of 20 min. sessions for some break in. Other than some wicked oversteer, no problems.
? Not getting any RPM reading at idle on the Micron. Went straight to the coil side of the kill switch. Any suggestions?
|
|
|
|
Post by Brad Wunder on Mar 2, 2011 0:35:00 GMT -5
Hey Rick, don't know why I didn't see this one till now. Sorry. I just wrap the lead from the Micron to the spark plug wire about 3 twists and it reads just fine. Did you try that?
|
|
warx
Full Member
Posts: 197
|
Post by warx on Mar 2, 2011 0:53:04 GMT -5
I was getting incorrect readings until I attached directly to coil side of kill switch and everything works great now - not sure why that would not work for you. Seems like it would be getting the strongest signal it could. Mine is a Mychron 4 2T.
|
|
|
|
Post by karlznet on Mar 5, 2011 16:15:33 GMT -5
It lives...... The 7A World Formula is running! Still have a few loose ends but pretty much ready to go. ~Karl
|
|
|
|
Post by Simon on Mar 5, 2011 19:05:02 GMT -5
Yay! All we need now is a race !
|
|
|
|
Post by brad42 on Mar 17, 2011 21:24:57 GMT -5
Still have a few loose ends ..... Hey Karl, remember this... Loose is fast! |
|
