World Formula valve lash and crank end float

[Simon]

1) What do you guys set your valve clearances to ?

2) Does anyone know what the end float on the crank should be ? I believe it's somewhere around 0.010" to 0.014", mine looks & feels way more than that (but I need to go and buy a dial gauge to be certain).

[Dan Pell]

Simon- The valve lash depends how your cam degrees out. If your looking for more low-end, looser is better, up to +.006. For top end, go the other way. Because the barell grows in height, clearance is greater at higher temps. As for end-play, .010 is not too much.